Vulnerabilidad · Publicado 19/07/2026 · Actualizado 01/08/2026
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mld: stop TX during firmware restart
When iwlwifi firmware crashes (e.g., NMI_INTERRUPT_UNKNOWN on Intel
BE201/Wi-Fi 7), iwl_mld_nic_error() sets mld->fw_status.in_hw_restart
to true. However, iwl_mld_tx_from_txq() does not check this flag before
dequeuing frames from mac80211 and pushing them to the transport lay…
In the Linux kernel, the following vulnerability has been resolved: wifi: iwlwifi: mld: stop TX during firmware restart When iwlwifi firmware crashes (e.g., NMI_INTERRUPT_UNKNOWN on Intel BE201/Wi-Fi 7), iwl_mld_nic_error() sets mld->fw_status.in_hw_restart to true. However, iwl_mld_tx_from_txq() does not check this flag before dequeuing frames from mac80211 and pushing them to the transport layer. Since the firmware is dead, iwl_trans_tx() returns -EIO for each frame, which then gets freed immediately. Under high-throughput conditions (e.g., Tailscale UDP traffic or active SSH sessions), this creates a tight dequeue-send-fail-free loop that wastes CPU cycles and generates rapid skb allocation churn, leading to memory pressure from slab fragmentation. The RX path already has this guard (iwl_mld_rx_mpdu checks in_hw_restart at rx.c:1906), and so does the TXQ allocation worker (iwl_mld_add_txqs_wk at tx.c:156). Add the same guard to iwl_mld_tx_from_txq() to stop all TX during firmware restart. Frames left in mac80211's TXQs are naturally drained after restart completes, when queue reallocation triggers iwl_mld_tx_from_txq() via iwl_mld_add_txq_list(), or when new upper-layer traffic invokes wake_tx_queue. Tested on ASUS Zenbook 14 UX3405CA with Intel BE201 (Wi-Fi 7) on kernel 6.19.5 where the firmware crashes approximately every 10-15 minutes under Tailscale traffic.
Score: 7.5/10 — Severidad: HIGH — Estado NIST: Awaiting Analysis
CVSS:3.1/AV:N/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:H
Publicado en NIST NVD.